Step 6: Clean any Vacuum Attachments.

The final step is to close the trap door at the bottom of the cylinder.Again, you should only do this once the bin has been re-attached to the vacuum cleaner.. You’ll know when the trap door has been properly closed, as there is a satisfying click.. Congratulations, your Dyson V6 is now emptied and ready to use!.

How Much Dirt Can The Dyson V6 Hold?.The Dyson V6 has a dirt capacity of 0.4 litres.This is relatively small, so you’ll need to empty it after most cleaning sessions.

It’s also smaller than the V7, V8, V10 and V11.. For this reason, it’s important to avoid the temptation of overfilling your Dyson V6.It can be frustrating to need to empty it so often, but overfilling will greatly reduce the vacuum cleaner’s performance..

If you need a larger Dyson cordless vacuum, then consider the Dyson V11 Outsize.

It’s an expensive model, but it comes with a large dust bin and a wider floorhead.. Do You Need To Pull Out Clumps By Hand When Emptying The V6?.Start by blotting up as much of the glue as possible, if it’s still wet.

If it’s dry, wet the area with a damp towel then use a blunt plastic knife to scrape away any excess (but be careful not to damage the carpet fibres.).Dip a white cloth into white vinegar, then dab the affected area so that the glue is wet.. Leave the vinegar on the carpet for 10-15 minutes so that it has time to break down the bonds in the glue..

Create a mixture of 250ml warm water and one tablespoon of washing up liquid.Using a clean cloth, dab this mixture onto the glue area and then blot it up with a different cloth to remove the stain.. With a new cloth, apply warm water to the area to rinse the carpet fibres.. Blot up the remaining liquid with a dry cloth and allow the carpet to completely dry..